+CWDHCPS=<lease time>,<start IP>,<end
OK
Set Command
Function:
Set the IP address range of the ESP SoftAP DHCP server.
Command:
AT+CWDHCPS=<enable>,<lease time>,<start IP>,<end
Response:
OK
Parameters
<enable>:
•
o
o
<lease time>: lease time. Unit: minute. Range [1,2880].
•
<start IP>: start IP address of the IP address range that can be obtained
•
from ESP SoftAP DHCP server.
•
<end IP>: end IP address of the IP address range that can be obtained
from ESP SoftAP DHCP server.
Notes
The configuration changes will be saved in the NVS area
•
if AT+SYSSTORE=1.
This AT command works only when both SoftAP and DHCP server are
•
enabled for ESP devices.
The IP address should be in the same network segment as the IP address
•
of ESP SoftAP.
Example
AT+CWDHCPS=1,3,"192.168.4.10","192.168.4.15"
AT+CWDHCPS=0
//
Disable the settings
AT+CWAUTOCONN: Automatically Connect to an
AP When Powered on
Set Command
© Copyright 2021 WIZnet Co., Ltd. All rights reserved.
IP>
1: Enable DHCP server settings. The parameters below have
to be set.
0: Disable DHCP server settings and use the default IP
address range.
and
use the default IP address
WizFi320 User Manual
IP>
range.
31