Wiznet WizFi320 User Manual page 40

Set Command
Command:
AT+WPS=<enable>[,<auth floor>]
Response:
OK
Parameters
<enable>:
•
o
o
<auth floor>: Wi-Fi authentication mode floor. ESP-AT will not connect to
•
the AP whose authmode is lower than this floor.
o
o
o
o
o
o
o
o
Notes
WPS can only be used when the ESP station is enabled.
•
WPS does not support WEP (Wired-Equivalent Privacy) encryption.
•
Example
AT+CWMODE=1
AT+WPS=1
AT+MDNS: Configure the mDNS Function
Set Command
Command:
AT+MDNS=<enable>[,<hostname>,<service_name>,<port>]
Response:
OK
Parameters
© Copyright 2021 WIZnet Co., Ltd. All rights reserved.
1: Enable WPS (Wi-Fi Protected Setup) that uses PBC (Push
Button Configuration) mode.
0: Disable WPS that uses PBC mode.
0: OPEN (Default)
1: WEP
2: WPA_PSK
3: WPA2_PSK
4: WPA_WPA2_PSK
5: WPA2_ENTERPRISE
6: WPA3_PSK
7: WPA2_WPA3_PSK
WizFi320 User Manual
40