Wiznet WizFi320 User Manual page 24

showing the corresponding parameters; if you set them as 0, it means
NOT showing the corresponding parameters.
o
o
o
o
o
o
o
o
o
o
o
• [<rssi filter>]: determine whether the result of the
command AT+CWLAP
words, the result of the command will NOT show the APs whose signal
strength is below
100,40].
[<authmode mask>]: determine whether APs with the following
•
authmodes are shown in the result of AT+CWLAP. Default: 0xFF. If you
set to 1, the APs with the corresponding authmode will be shown. If
bit x
you set
bit x
shown;
o
o
o
o
o
o
o
o
© Copyright 2021 WIZnet Co., Ltd. All rights reserved.
bit 0: determine whether <ecn> will be shown.
bit 1: determine whether <ssid> will be shown.
bit 2: determine whether <rssi> will be shown.
bit 3: determine whether <mac> will be shown.
bit 4: determine whether <channel> will be shown.
bit 5: determine whether <freq_offset> will be shown.
bit 6: determine whether <freqcal_val> will be shown.
bit 7: determine whether <pairwise_cipher> will be shown.
bit 8: determine whether <group_cipher> will be shown.
bit 9: determine whether <bgn> will be shown.
bit 10: determine whether <wps> will be shown.
will be filtered according to
. Unit: dBm. Default: –100. Range: [–
rssi filter
to 0, the APs with the corresponding authmode will NOT be
bit 0: determine whether APs with
shown.
bit 1: determine whether APs with
bit 2: determine whether APs with
shown.
bit 3: determine whether APs with
shown.
bit 4: determine whether APs with
be shown.
bit 5: determine whether APs with
will be shown.
bit 6: determine whether APs with
shown.
bit 7: determine whether AP with
be shown.
WizFi320 User Manual
. In other
rssi filter
authmode will be
OPEN
authmode will be shown.
WEP
authmode will be
WPA_PSK
authmode will be
WPA2_PSK
authmode will
WPA_WPA2_PSK
authmode
WPA2_ENTERPRISE
authmode will be
WPA3_PSK
authmode will
WPA2_WPA3_PSK
24