Query the IP address of the ESP Station.
Command:
AT+CIPSTA?
Response:
+CIPSTA:ip:<"ip">
+CIPSTA:gateway:<"gateway">
+CIPSTA:netmask:<"netmask">
+CIPSTA:ip6ll:<"ipv6
addr">
+CIPSTA:ip6gl:<"ipv6
addr">
OK
Set Command
Function:
Set the IPv4 address of the ESP station.
Command:
AT+CIPSTA=<"ip">[,<"gateway">,<"netmask">]
Response:
OK
Parameters
•
<"ip">: string parameter showing the IPv4 address of the ESP station.
<"gateway">: gateway.
•
<"netmask">: netmask.
•
•
<"ipv6 addr">: string parameter showing the IPv6 address of the ESP
station.
Notes
For the query command, only when the ESP station is connected to an AP
•
or the static IP address is configured can its IP address be queried.
The configuration changes will be saved in the NVS area
•
if AT+SYSSTORE=1.
The Set Command correlates with the commands that set DHCP, such
•
as AT+CWDHCP.
o
o
© Copyright 2021 WIZnet Co., Ltd. All rights reserved.
If static IP address is enabled, DHCP will be disabled;
If DHCP is enabled, static IP address will be disabled;
WizFi320 User Manual
36