Wiznet WizFi320 User Manual page 23

o
o
• <repeat_count>: the number of attempts the ESP device makes to
reconnect to the AP. This parameter only works when the
parameter
o
o
Example
// The ESP station tries to reconnect to AP at the interval of one second
times.
AT+CWRECONNCFG=1,100
// The ESP station will
AT+CWRECONNCFG=0,0
Notes
The parameter
•
parameter
This command works for passive disconnection from APs, Wi-Fi mode
•
switch, and Wi-Fi auto connect after power on.
AT+CWLAPOPT: Set the Configuration for the
Command
Set Command
Command:
AT+CWLAPOPT=<reserved>,<print
Response:
OK
or
ERROR
Parameters
<reserved>: reserved item.
•
• <print mask>: determine whether the following parameters are shown in
the result of AT+CWLAP. Default: 0x7FF. If you set them to 1, it means
© Copyright 2021 WIZnet Co., Ltd. All rights reserved.
0: The ESP station will not reconnect to the AP when
disconnected.
[1,7200]: The ESP station will reconnect to the AP at the
specified interval when disconnected.
is not 0. Default: 0. Maximum: 1000.
<interval_second>
0: The ESP station will always try to reconnect to AP.
[1,1000]: The ESP station will attempt to reconnect to AP for
the specified times.
not reconnect to AP when
<interval_second>
of the command AT+CWJAP.
[<reconn_interval>]
AT+CWLAP
mask>[,<rssi filter>][,<authmode mask>]
WizFi320 User Manual
disconnected.
of this command is the same as the
for 100
23