o
o
<error code>: (for reference only)
•
o
o
o
o
o
Notes
The configuration changes will be saved in the NVS area
•
if AT+SYSSTORE=1.
This command requires Station mode to be enabled.
•
The parameter
•
as
<interval_second>
if you omit
between Wi-Fi reconnections will use the default value 1.
If the
•
<ssid>
configuration.
Execute command has the same maximum timeout to setup command.
•
The default value is 15 seconds, but you can change it by setting the
parameter
•
To get an IPv6 address, you need to set AT+CIPV6=1.
Response
•
network. At present, ESP-AT is mainly based on IPv4 network,
supplemented by IPv6 network.
•
WIFI GOT IPv6 LL
obtained. This address is calculated locally through EUI-64 and does not
require the participation of the AP. Because of the parallel timing, this print
may be before or after
•
WIFI GOT IPv6 GL
obtained. This address is combined by the prefix issued by AP and the
suffix calculated internally, which requires the participation of the AP.
© Copyright 2021 WIZnet Co., Ltd. All rights reserved.
bit 0: PMF capable, advertizes support for protected
management frame. Device will prefer to connect in PMF mode
if other device also advertizes PMF capability.
bit 1: PMF required, advertizes that protected management
frame is required. Device will not associate to non-PMF
capable devices.
1: connection timeout.
2: wrong password.
3: cannot find the target AP.
4: connection failed.
others: unknown error occurred.
<reconn_interval>
of the command AT+CWRECONNCFG. Therefore,
when running this command, the interval
<reconn_interval>
and
parameter are omitted, AT will use the last
<password>
.
<jap_timeout>
means that the IPv4 network is ready, but not the IPv6
OK
represents that the linklocal IPv6 address has been
.
OK
represents that the global IPv6 address has been
WizFi320 User Manual
of this command is the same
21