Sony FVS-1000 Maintenance Manual page 125

2. Removing the processor assembly
n
When removing the processor assembly from the
unit, be sure to perform the procedure by more
than two persons.
(1) Remove the four screws and trapezoid
washer.
(2) Holding the handle, pull out the processor
assembly to the front (15 cm).
(3) Disconnect the CN3 connector (rear) of the
processor assembly from the rear of the unit.
(4) Pull out the processor assembly to the
position hooking the stopper.
(5) Press the lock lever of the slide rail in the
arrow direction.
(6) Holding the handle on the side of the proces-
sor assembly, and remove from the unit.
Installation
3. Installing the processor assembly
(1) Pull out the slide rail of the unit.
(2) Insert the rail of the processor assembly
slowly into the slide rail of the unit.
(3) Push in the processor assembly completely.
n
Firmly push in the two power connectors of
the processor assembly to the connectors of
the unit until they connect.
(4) Connect the connector CN3 (rear) of the
processor assembly from the rear of the unit.
(5) Secure the processor assembly with the four
screws and trapezoid washer.
4. Installing the camera cable
Connect the camera cable removed in step 1, and
install the front cover.
FVS-1000 MMP1
http://getMANUAL.com
Trapezoid
washer
RK5 x 14
Processor assembly
RK5 x 14
4-10. Replacing the Processor Assembly
CN3
Power supply
connector
Lock lever
Slide rail
Hundle
Trapezoid washer
Flat cable
4-15