Table of Contents
Advertisement
12. Insert the processor board along the guide rail.
n
. When inserting the processor board, confirm the processor board name on the label.
. Insert the processor board completely until the connector is connected.
13. Connect the flat cable with the CN6027 connector on the MY-89 board.
14. Connect the three coaxial cables with the CN402, 702 and 120 connectors on the ADC-36 board.
15. Install the front cover, then tighten four screws.
n
Pull out the flat cable and the coaxial cables connected with the processor boards through the notch of
the front panel, then fix with the clip plate and two screws (PSW3 x 6).
Top view
Notch
Clip plate
Rear side
1. Remove the two screws, then remove the cover.
FVS-1000 MMP1
Cable
Card board
Handle
Harness
band
Front cover
PSW3 x 6
Clip plate
Screw
Screw
Cover
ADC-36 board
MY-89 board
Label
Flat cable
Coaxial cables
1-10. Installation Procedure
CN402
CN702
CN6072
CN102
1-19
Advertisement
Table of Contents
