Table of Contents
Advertisement
1-10. Installation Procedure
5. Remove the cover of the terminal table.
6. Connect the specified power supply code with the terminal table as shown in the following figure.
7. Install the cover to the terminal table.
Cover
Green head
Terminal
table
8. Install the power supply cover and rear panel in the reverse order of procedure 1 to 4.
n
Pull out the power supply code through the notch of the rear panel.
5. Installation of the air blow assembly
1. Loosen the four screws of the rear panel.
2. Hang the air blow assembly on the four screws loosened in procedure 1 with passing the screws
through the holes on the four corners of the air blow assembly.
3. Remove the four screws, then remove the air filter cover from the air blow assembly.
B4 x 8
Air blow assembly
1-10
Power supply
M6
code
B G/Y
W
B4 x 8
Air filter cover
B3 x 6
B3 x 6
FVS-1000 MMP1
Advertisement
Table of Contents
