Table of Contents
Advertisement
Rear view
Removal
1. Loosen the two screws (with stopper) at the top and bottom of the board panel alternately.
2. Pull out the processor board from the guide rail.
Installation
3. Insert the processor board along the guide rail.
4. Tighten the upper and lower knobs one after the other several times, then insert the connector com-
pletely until the connector is connected.
n
Be sure to tighten the two screws one after the other.
If one screw is tightened completely first, there is a possibility of damaging the connector or screw.
FVS-1000 MMP1
Screw (with stopper)
2-8. Removing/Installing the Board
2-35
Advertisement
Table of Contents
