Table of Contents
Advertisement
2-8. Removing/Installing the Board
2-8. Removing/Installing the Board
2-8-1. Processor Board (FVS-P1000) and BKFV-100/200
Front side
Removal
1. Open the door at the bottom of the unit.
2. Loosen the four screws (with stopper), and remove the front cover.
3. Disconnect the flat cable from the connector CN6027 of the MY-89 board.
4. Disconnect the three coaxial cables from the connectors CN402, CN702, and CN102 of the ADC-36
board.
5. Pull out the processor board from the guide rail.
Top view
Notch
Clip plate
Screw
(with stopper)
Front cover
Screw
(with stopper)
Installation
6. Perform the reverse of steps 1 to 5 of the removal procedure.
n
. When inserting the processor board, confirm the processor board name on the label.
. Insert the processor board completely until the connector is connected.
. Pull out the flat cable and the coaxial cables connected with the processor boards through the notch
of the front panel, then fix them with the clip plate and two screws (PSW3 x 6).
2-34
Cable
Card board
Handle
Harness
band
PSW3 x 6
Clip plate
Label
ADC-36 board
MY-89 board
Flat cable
Coaxial cable
Screw (with stopper)
CN402
CN702
CN6072
CN102
FVS-1000 MMP1
Advertisement
Table of Contents
