Table of Contents
Advertisement
1-10. Installation Procedure
c
Connect the safety ground. If the safety ground is not connected, there is a danger of an electrical shock.
1. Remove nine screws, then remove the rear panel.
B4 x 8
Rear panel
B4 x 8
2. Remove the two screws and flap subpanel.
3. Prop the subpanel with rod.
4. Loosen the two screws, then remove the power supply cover in the direction of arrow.
Sub panel
Power supply cover
B3 x 6
B3 x 6
Rod
PSW4 x 8
1-9
FVS-1000 MMP1
Advertisement
Table of Contents
