Removing The Power Supply Unit Blank - Dell PowerEdge R430 Owner's Manual

Figure 74. Installing a cabled PSU
1. PSU
3. P1 cable connector
5. P3 cable connector
7. backplane connector
Next steps
1. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 71
Related tasks
Before working inside your system
After working inside your system

Removing the power supply unit blank

Install the power supply unit (PSU) blank only in the second PSU bay.
Steps
If you are installing a second power supply unit (PSU), remove the PSU blank in the bay by pulling the blank outward.
CAUTION: To ensure proper system cooling, the PSU blank must be installed in the second PSU bay in a
non-redundant configuration. Remove the PSU blank only if you are installing a second PSU.
140 Installing and removing system components
on page 72
on page 72
2. screw
4. P2 cable connector
6. standoff