Installing The Control Panel Module - Dell PowerEdge R430 Owner's Manual

Figure 94. Removing the control panel module—four hard-drive chassis
1. control panel module
3. control panel module connector cable
5. USB connector cable
Related references
Safety instructions on page 71
Related tasks
Before working inside your system

Installing the control panel module

After working inside your system
Installing the control panel module
Steps
1. For a 3.5 inch cabled hard drive system:
a. Insert the LED panel into the slot in the chassis.
b. Secure the LED panel with the screws.
2. Insert the control panel module into the slot in the chassis and align the two screw holes on the control panel module with
the corresponding holes on the chassis.
3. Secure the control panel module with the screws.
4. Connect all the applicable cables to the control panel module.
on page 72
on page 157
on page 72
2. control panel module screws (2)
4. display module cable
Installing and removing system components 157