Installing The Cooling Shroud; System Memory - Dell PowerEdge R430 Owner's Manual

Installing the cooling shroud

Prerequisites
1. If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing
bracket.
Steps
1. Align the tabs on the cooling shroud with the securing slots on the chassis.
a. Align the cooling shroud with the guide pin on the system board.
b. Align the intrusion switch with the intrusion switch connector on the system board.
2. Lower the cooling shroud into the chassis until it is firmly seated.
When firmly seated, the memory socket numbers marked on the cooling shroud align with the respective memory sockets.
Figure 24. Installing the cooling shroud
1. cooling shroud
3. intrusion switch connector on the system board
5. guide pin
Related references
Safety instructions on page 71
Related tasks
Before working inside your system
After working inside your system

System memory

Your system supports DDR4 registered DIMMs (RDIMMs).
MT/s indicates DIMM speed in MegaTransfers per second.
NOTE:
Memory bus operating frequency can be 2400 MT/s, 2133 MT/s, or 1866 MT/s depending on the following factors:
● System profile selected (for example, Performance Optimized, Custom, or Dense Configuration Optimized)
● Maximum supported DIMM frequency of the processors
80 Installing and removing system components
on page 72
on page 72
2. intrusion switch
4. guide on the cooling shroud