Dell PowerEdge R430 Owner's Manual page 107

2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Align the two notches on the metal standoffs with the slots on the side of the optical drive.
2. Slide the optical drive into the notches until it is seated firmly and the release latch snaps into place.
3. Connect the power cable.
4. Connect the data cable to the back of the drive and to the SATA connector on the system board.
Route and secure the cables using the cable routing latch on the system chassis to prevent them from being
NOTE:
pinched or crimped.
Figure 45. Installing the standard optical drive
1. optical drive
3. power cable
5. metal standoff (4)
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 71
Related tasks
Before working inside your system
After working inside your system
on page 72
on page 72
2. data cable
4. release latch
6. notch on the metal standoff (2)
Installing and removing system components 107