Troubleshooting The Video Subsystem; Troubleshooting A Usb Device; Troubleshooting A Serial Input And Output Device - Dell PowerEdge R430 Owner's Manual

Troubleshooting the video subsystem

Steps
1. Check the system and power connections to the monitor.
2. Check the video interface cabling from the system to the monitor.
3. Run the appropriate diagnostic test.
Results
If the tests run successfully, the problem is not related to video hardware.

Troubleshooting a USB device

Prerequisites
Follow steps 1 to 6 to troubleshoot a USB keyboard or mouse. For other USB devices, go to step 7.
NOTE:
Steps
1. Disconnect the keyboard and/or mouse cables from the system and reconnect them.
2. If the problem persists, connect the keyboard and/or mouse to another USB port on the system.
3. If the problem is resolved, restart the system, enter System Setup, and check if the non-functioning USB ports are enabled.
Older operating systems may not support USB 3.0.
NOTE:
4. Check if USB 3.0 is enabled in System Setup. If enabled, disable it and see if the issue is resolved.
5. In iDRAC Settings Utility, ensure that USB Management Port Mode is configured as Automatic or Standard OS Use.
6. If the problem is not resolved, replace the keyboard and/or mouse with a known working keyboard or mouse.
If the problem is not resolved, proceed to step 7 to troubleshoot other USB devices attached to the system.
If the problem is not resolved, proceed to troubleshoot other USB devices attached to the system.
7. Turn off all attached USB devices, and disconnect them from the system.
8. Restart the system.
9. If your keyboard is functioning, enter System Setup, verify that all USB ports are enabled on the Integrated Devices
screen. If your keyboard is not functioning, use remote access to enable or disable the USB options.
10. Check if USB 3.0 is enabled in System Setup. If it is enabled, disable it and restart your system.
11. If the system is not accessible, reset the NVRAM_CLR jumper inside your system and restore the BIOS to the default
settings. See the System board jumper setting section
12. In the IDRAC Settings Utility, ensure that USB Management Port Mode is configured as Automatic or Standard OS
Use.
13. Reconnect and turn on each USB device one at a time.
14. If a USB device causes the same problem, turn off the device, replace the USB cable with a known good cable, and turn on
the device.
Related references
Getting help on page 187
System board jumper settings

Troubleshooting a serial input and output device

Steps
1. Turn off the system and any peripheral devices connected to the serial port.
on page 170
Troubleshooting your system 175