Table of Contents
Advertisement
Figure 18. Installing the power module assembly
3.
Install the rear
cover.
Next steps
Follow the procedure listed in
Power supply unit
NOTE:
While replacing the hot swappable PSU, after next server boot; the new PSU automatically updates to the same
firmware and configuration of the replaced one. For updating to the latest firmware and changing the configuration, see the
Lifecycle Controller User's Guide at https://www.dell.com/idracmanuals.
Removing a power supply unit blank
Prerequisites
Follow the safety guidelines listed in the
Steps
Pull the PSU blank out of the system.
CAUTION:
To ensure proper system cooling, the PSU blank must be installed in the second PSU bay in a
non-redundant configuration. Remove the PSU blank only if you are installing a second PSU.
26
Installing and removing system components
After working inside your
Safety
instructions.
system..
Advertisement
Table of Contents
