Installing The Power Interposer Board - Dell PowerEdge R430 Owner's Manual

Steps
1. Disconnect the power distribution cables from the system board.
2. Disconnect the fan cable.
3. Remove the two screws securing the PIB to the chassis and lift the board out of the chassis.
Figure 96. Removing the power interposer board
1. standoffs (2)
3. fan cable connector
5. PSU cables to the system board (3)
Next steps
Follow the procedure listed in After working inside your system section.
Related references
Safety instructions on page 71
Related tasks
Before working inside your system
Removing a redundant power supply unit

Installing the power interposer board

Installing a redundant power supply unit
After working inside your system
Installing the power interposer board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in Before working inside your system section.
on page 72
on page 136
on page 159
on page 137
on page 72
2. power interposer board
4. screw (2)
Installing and removing system components 159