Dell PowerEdge R430 Owner's Manual page 48

Viewing Network Settings
To view the Network Settings screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
NOTE:
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Network Settings.
Related references
Network Settings on page 47
Network Settings screen details
Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
Option Description
Enables or disables the device. When enabled, a UEFI boot option is created for the device.
PXE Device n (n
= 1 to 4)
Enables you to control the configuration of the PXE device.
PXE Device n
Settings(n = 1 to
4)
Related references
Network Settings on page 47
Related tasks
Viewing Network Settings
UEFI iSCSI Settings
You can use the iSCSI Settings screen to modify iSCSI device settings. The iSCSI Settings option is available only in the UEFI
boot mode. BIOS does not control network settings in the BIOS boot mode. For the BIOS boot mode, the option ROM of the
network controller handles the network settings.
Related references
UEFI iSCSI Settings details
UEFI iSCSI Settings on page 48
Related tasks
Viewing UEFI iSCSI Settings
48 Pre-operating system management applications
on page 48
on page 48
on page 49
on page 49