Removing The Optional Internal Dual Sd Module - Dell PowerEdge R330 Owner's Manual

Next steps

Removing the optional internal dual SD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the SD cards.
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards
into the corresponding slots.
Steps
1. Locate the internal dual SD module (IDSDM) on the system board. To locate the internal dual SD module connector, see the
System board connectors section.
2. Holding the pull tab, lift the IDSDM out of the system.
Figure 70. Removing the internal dual SD module (IDSDM)
1. IDSDM
3. IDSDM connector
The following table describes the IDSDM indicator codes:
Table 26. IDSDM indicator codes
Convention
A
B
C
D
IDSDM indicator code
Green
Flashing green
Flashing amber
Amber
2. pull tab
Description
Indicates that the card is online.
Indicates rebuild or activity.
Indicates card mismatch or that the card has failed.
Indicates that the card is offline, has failed, or is write
protected.
107