Printing A Network Information Label - Avery Dennison MONARCH 9493 System Administrator Manual

Setting the Command Escape Character
1. This option allows you to set or view the Command Escape Character (CEC).
2. Run-time messages from the radio begin with the CEC and the default is the pound sign (#),
which has a decimal value of 35. You may need to change the default CEC character if it
conflicts with other data, because an unexpected operation could occur. The range is a
decimal value between 1 and 255.
3. From the Configure menu, select Escape.
Escape Char
+ 35
E R
Use A as shown in the following table:
E
Press A to
Saves the setting
When the setting you want is displayed, press E to save the setting. You return to the
4.
Configure menu.
Press F to exit.
5.
When you select "Exit" after configuring, you will see
Configure
Save Settings ?
E X
To save all the configuration settings, press E. To exit without saving the configuration
settings, press X . Press F until you see "Ready."
Note: You must reset the RF network before your changes take effect. See "Resetting the RF
Network" for more information.

Printing a Network Information Label

You can print a network information label with the device name, IP address, and MAC address
as a Code 128 bar code. You can also print the network information as a Code 39 bar code with
the correct MIF settings.
1. Turn on the printer.
Press A under <T>. You see the printer's IP address. For example,
2.
192.0.0.192
Press A under
3.
2-8 System Administrator's Guide
+
R
Press A to
Scrolls through the positions
from left to right
to print a network information label.
+
Press A to
Increments the current position
setting by 1
Sample Label