Table of Contents
Advertisement
Switching off the 218 with the remote control
Press the (POWER) button on your remote control.
The device is switched to standby mode and the POWER LED (
$
To switch off the
completely, set the power switch (
218
OFF position.
SELECTING THE LED COLOURS
To customise the POWER LED (
of two configurations:
(Standard)
1.
2.
2.
4.
To change the colour scheme, the 218 must be in standby mode.
Press and hold the POWER switch (
$
AUTO POWER DOWN
The
has an auto power down (APD) function. This ensures that the
218
to standby mode if there is no input signal for a period of approx.
The APD function is switched on when the
off at the device, with the remote control or via BurLink.
To switch APD on and off, the 218 must be switched on (ON state):
Switching the APD on and off at the device
To switch off the APD function directly at the device, press and hold the
POWER button (
) for
seconds.
1
5
$
The front LED (
2
) briefly flashes red three times.
To switch the APD function back on directly at the device, press and hold the
POWER button (
1
) again for
The front LED (
) briefly flashes green three times.
$
2
6
2
) colours to suit your preferences, you can choose one
STBY = Red
STBY = Orange
) for about
seconds.
1
10
218
is delivered. It can be switched on and
5
seconds.
2 1 8
P O W E R
A M P L I F I E R
) changes colour.
2
) on the back of the device to
ON = Green
3.
ON = Red
5.
switches
218
30
minutes.
3 7 | 4 6
Advertisement
Table of Contents
