Simulation" Submenu - Endress+Hauser Levelflex FMP53 HART Operating Instructions Manual

Operating menu
184
16.4.6

"Simulation" submenu

The Simulation submenu is used to simulate specific measuring values or other
conditions. This helps to check the correct configuration of the device and connected
control units.
Conditions which can be simulated
Condition to be simulated
Specific value of a process variable
Specific value of the output current
Specific state of the switch output
Existence of an alarm
Existence of a specific diagnostic message
Levelflex FMP53 HART
Associated parameters
• Assign measurement variable (→  186)
• Process variable value (→  186)
• Current output simulation (→  186)
• Value current output (→  187)
• Switch output simulation (→  187)
• Switch status (→  187)
Device alarm simulation (→  188)
Diagnostic event simulation (→  188)
Endress+Hauser