Danfoss VLT HVAC Drive Instruction Manual page 4

Danfoss FC Drive LCP Bottom Line Status Messages
GROUP 1 – First (left) word: Type of Control
Operating mode
The navigation keys on the LCP can be used to control the drive. Stop commands, reset,
Hand
reversing, DC brake, and other signals applied to the control terminals override local control.
Off
The drive does not react to any control signal until Auto On or Hand On is pressed.
The drive requires external commands to execute functions. The start/stop commands are
Auto
sent via the control terminals and/or the serial communication.
GROUP 2 – Second (middle) word: Reference Site
Reference site
Local
The drive uses reference values from the LCP.
The speed reference is given from external signals, serial communication, and/or internal
Remote
preset references.
NOTE: The Reference Site is determined by P 3‐13. The default value is [0] Linked to Hand/Auto.
1 Type of Control
2 Reference Site
3 Operation Status
Description
Description
3