Local Control using the LCP (Local Control Panel)
In this lab you will set up a VLT HVAC drive to operate in Hand Mode. This is the simplest form of
operation and consists of using the drive's LCP to operate the drive manually. No external control
wiring is required. If your control box is connected, set all switches to OFF. You will use the Quick
Setup menu to set up the basic parameters required for local control.
Learn how to access the FC 102's software quick menus
Program & understand the Quick Setup parameters
Start the drive and change the motor speed using the LCP
VLT HVAC Drive Lab # 1
Introduction
Behavioral Objectives
18
(Local Control Panel)