Danfoss VLT HVAC Drive Instruction Manual page 18

Hide thumbs Also See for VLT HVAC Drive:

Reading from a drive

Drives that were previously programmed and operating in the field can be backed up to an MCT 10

project file. There are 2 ways to accomplish this. To back up a drive's active parameter settings to

project file, follow the instructions listed below.

Method 1

 Connect to a live drive via USB or serial communication

 Highlight the connected drive with the mouse

 Right click, select Copy and wait until it's finished

 Highlight the project, right click and select Paste

Method 2

 Open MCT 10 and create a new project drive that mimics the actual drive

 Highlight the project drive of interest that has default settings

 Right click, select Read from Drive and wait until it's finished

The project drive will now have the same parameter settings as the actual drive. You can save the

project (File –> Save As) to your laptop and the settings will now be securely stored.

This guide is just a basic introduction of MCT 10 setup software functionality, and there are many

other features that have not been discussed. Take some time to explore the software and uncover

some useful features on your own. Right clicking will often bring up other available options

including comparisons, scope traces, copy & paste features and a whole lot more.