Danfoss VLT HVAC Drive Instruction Manual page 36

Conn. Term. Input/Output
1, 2 Input
3, 4 Input
5, 6 Input
X55
7, 8 Input
9, 10 Output
11, 12 Output
1, 2 Output
3, 4 Output
5, 6 Output
7 Output
X56
8 Output
9 Output
10 Input
11 Input
12 Input
X58
1, 2 Output
Terminal(s) Parameter
P 5‐40
1, 2 P 5‐41
P 5‐42
19 P 5‐11
18 P 5‐10
P 5‐00
27 P 5‐01
P 5‐12
P 5‐02
29
P 5‐31
Note: If the drive is reinitialized, be sure to change P 0‐03 Regional Settings to [1] North America and change the
highlighted parameter values above for proper bypass operation. All other listed parameters are default values.
Name
Remote Drive Start (with common start/stop)
Remote Drive Start (without common start/stop)
Motor Running on Drive
Run request (for run permissive)
Run Enable (for run permissive)
Safety Stop
Drive Fault
Fire Mode
Remote Motor 1 Select
Remote Motor 2 Select
Motor 1 Selected
Motor 2 Selected
Drive Mode
Bypass Mode
Fire Mode
EMB2 Control Card Terminal Functions
Type
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Common form C relay contact
Normally closed form C relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
Normally open, dry relay contact
EMB2 Control Card Parameter Settings
Name
RELAY 1 – Function
RELAY 1 – On Delay
RELAY 1 – Off Delay
Terminal 19 Digital Input
Terminal 18 Digital Input
Digital I/O Mode
Terminal 27 Mode
Terminal 27 Digital Input
Terminal 29 Mode
Terminal 29 Digital Output
EMB2 Control Card Typical Control Connections
Input Command
Input Command
Output Status
Output Command
Input Command
Input Command
Output Status
Input Command
Input Command
Input Command
Output Status
Output Status
Output Status
Output Status
Output Status
Closed when motor can start to run
Closed for remote start with common start/stop
Safety input, open to stop
Closed to enable Fire Mode
Closed indicates Fire Mode activated
Closed indicates Motor 1 selected
Closed indicates Motor 2 selected
Closed when panel is in Drive Mode
Closed when panel is in Bypass Mode
Open when drive is in Fault Condition
Common for fault relay
Closed when drive is in Fault Condition
CMS Motor 2, close to select
CMS common
CMS Motor 1, close to select
Closed indicates run requested
Value
[167] Start Command Active
0.01 s
0.01 s
[52] Run permissive
[8] Start
[0] PNP ‐ Active at 24V
[0] Input
[7] External Interlock
[1] Output
[160] No Alarm
Drive
Function
Terminals
13, 18
04, 05, 06
35
Function
Function
Run permissive
Common run/stop
External interlock
Auto bypass
EMB2 EMB2 EMB2
X56 X55 X58
3, 4
1, 2
1, 2
5, 6
7, 8, 9
7, 8
11, 12
10, 11
11, 12
1, 2
3, 4
5, 6
9, 10