Connecting Power And Communication - Agilent Technologies Pump Module Original User Manual

96AM Wash Station
8-Channel Wash Station

Connecting power and communication

Before you begin
Pump Module User Guide
Figure Tip Wash Station secured to a platepad
The 96AM Wash Station is a 96- chimney Tip Wash Station that is scaled for
the Bravo 96AM head as part of the AssayMAP Bravo Platform. The 96AM
Wash Station requires a bracket to secure it to the platepad. Typically, an
Agilent representative will set up the 96AM Wash Station when installing the
AssayMAP Bravo Platform. For setup instructions, see the user documentation
for the liquid- handling device at
The 8- Channel Wash Station is a wash station used on the Encore Multispan
System. For installation instructions, see the section on setting up accessories
in the Encore Multispan System knowledge base located at
chem/askb.
•
Ensure that the Pump Module location meets the site requirements. See
"Laboratory setup requirements" on page
•
Make sure you have the Pump Module power cord and communication
cable.
WARNING
Ensure that the power cords are in good condition and are not frayed. Use of
frayed or damaged power cords can cause injury.
WARNING
Ensure that the Pump Module and the associated liquid-handling device are
turned off before connecting the cables and routing the tubing.
Connecting power and communication
www.agilent.com/chem/askb.
6.
Pump Module User Guide
www.agilent.com/
15