Table of Contents
Advertisement
Workflow for routing the tubing
Connecting tube A to a reservoir or wash station on a platepad or Weigh Station
Pump Module User Guide
Item Component
Description
8
3- way
Reservoirs with two inlet or outlet ports. Enables one
connector
tube to branch into two tubes at the input and output
ports on an autofilling reservoir, such as the Tip Wash
Station.
WARNING
Ensure that the Pump Module and the liquid-handling device are turned off
before routing the tubing.
Perform the following procedures in the order given:
Step
For this task...
1
Connect tube A (smaller
diameter tubing) to the
reservoir ports.
2
Position tube B (larger
diameter tubing) in the pump
heads.
3
Connect tube B from the
pump heads to tube A from
the reservoir.
4
Connect tube B from the
pump heads to tube A from
source and waste bottles.
5
Auto Filling Reservoir only.
Connect a length of tube B
from the overflow gravity-
drain to a waste bottle.
6
Complete the Pump Module
setup.
Refer to the following figure for this procedure.
Pump Module User Guide
Routing the tubing
See...
Use one of the following:
•
"Connecting tube A to a
reservoir or wash station on a
platepad or Weigh Station" on
page 19
•
"Connecting tube A to a
reservoir installed on the
Vertical Pipetting Station" on
page 20
•
"Connecting tube A to the
8- Channel Wash Station" on
page 21
"Positioning tube B in the pump
heads" on page 21
"Connecting tube B between the
Pump Module and the reservoir" on
page 23
"Connecting tube B to source and
waste bottles" on page 24
"(Auto Filling Reservoir only)
Connecting tube B to the gravity
drain" on page 24
"Completing the Pump Module
setup" on page 24
19
Advertisement
Table of Contents
