Connecting The Nitrogen Generator Power - Agilent Technologies 4107 User Manual

Installation
Nitrogen
inlet on the
MP-AES
Figure 4. Nitrogen inlet on the bottom right side of the MP-AES instrument
Figure 5. Nitrogen inlet on the EGCM
3

Connecting the nitrogen generator power

To connect the electrical power to the nitrogen generator:
1
2
Plug the AC supply cable in to an outlet complying with the nitrogen generator
NOTE
requirements specified in the Agilent MP-AES Site Preparation Guide.
20
Ensure that the fittings are tightened firmly.
Plug the small DC output connector from the power supply to the
receptacle on the rear of the nitrogen generator. See Figure 3.
Plug the AC supply cable into the power supply.
Nitrogen
inlet on the
EGCM
Agilent 4107 Nitrogen Generator User's Guide