Receiver Control - Auto
If the receiver control field is set to auto (see
receiver frequency is set according to the fields or GPIB commands in the following table.
Table 1. Test Set Receiver Frequencies (Receiver Control = Auto)
Test Function
Receiver Frequency Fields
BCH
Broadcast Chan (1)
BCH + TCH
Traffic Channel (2)
CW
RF Gen Channel
XXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
Table Footnotes
1
Actual frequency depends on current broadcast band (PGSM, EGSM, PCS, or DCS), and is
defined in GSM as the uplink frequency.
2
Actual frequency depends on current traffic channel band (PGSM, EGSM, PCS, or DCS), and
is defined in GSM as the uplink frequency.
Receiver Control - Manual
If the Receiver Control field is set to Manual (see
receiver frequency is set according to the fields or GPIB commands in the following table.
Table 2. Test Set Receiver Frequencies (Receiver Control = Manual)
Test Function
Receiver Frequency Fields
Don't Care
Manual Channel (1)
Manual Frequency
XXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
Table Footnotes
1
Actual frequency is defined in GSM as the uplink frequency.
"RFANalyzer:CONTrol:AUTO" on page
GPIB Command
"CALL[:CELL]:BCHannel[:ARFCn][:SELected]" on page 236
"CALL:TCHannel[:ARFCn][:SELected]" on page 287
"CALL[:CELL]:BCHannel[:ARFCn][:SELected]" on page 236
"RFANalyzer:CONTrol:AUTO" on page
GPIB Command
"RFANalyzer:MANual:CHANnel[:SELected]" on page 375
"RFANalyzer:MANual:FREQuency" on page 378
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_bse_test.fm
Test Mode Operating Mode
372), the test set's
372), the test set's
525