Agilent Technologies 8960 10 Series Reference Manual page 289

CALL:TCHannel[:ARFCn]:PGSM
Function Set channel number for downlink and uplink TCH for PGSM band. See
Channel (TCH)" on page
TCH ARFCN may be set and queried when the CALL:STATUS:STATE is idle or connected, see
"CALL:STATus[:STATe]?" on page
Additional commands can be appended to aid in controller/Mobile Station synchronization. See
"Call Processing Subsystem Overlapped Command Synchronization Commands" on page 31
examples.
Setting range: 1 to 124 (default: 30)
resolution: 1
Query range: 1 to 124
resolution: 1
*RST Setting 30 (PGSM band)
Programming Example
OUTPUT 714;"CALL:TCHANNEL:ARFCN:PGSM 124"
CALL:TCHannel:BAND
Function Sets/queries which GSM band the BS Emulator should use for the TCH.
The test set may be queried for the current TCH band when the CALL:STATUS:STATE is idle or
connected, see
The test set uses this command to perform a channel assignment, see
Handover" on page 119
CONNected.
Setting range: DCS | EGSM | PCS | PGSM bands
resolution: 1
Query range: DCS | EGSM | PCS | PGSM bands
resolution: 1
*RST Setting PGSM
Related Topic Frequency Banded Parameters
Programming Example
OUTPUT 714;"CALL:TCHANNEL:BAND DCS"
521.
283.
"CALL:STATus[:STATe]?" on page
when the MS will support the band and the CALL:STATUS:STATE is
"Traffic Band Parameter" on page 502
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_call_tchannel.fm
"Configuring the Traffic
283.
"Programming a Dualband
.
CALL:TCHannel
for
289