Agilent Technologies 8960 10 Series Reference Manual page 429

SETup:PVTime:TIME[:OFFSet]
Function Sets/queries the time offsets in seconds for power vs time power measurement, (not the mask
measurement).
All 12 time offsets are set to on by default. If less than 12 values are sent with this command, the
remaining offsets are turned off, see
These values are referenced to the occurrence of bit 0 in a normal burst.
The units (S|MS|US|NS) are optional, if no units are specified then units default to S.
Range: 0 to 12 comma-separated values ranging from: −50 us to 593 µs
Setting
Resolution: 1 ns
Range: 0 to 12 comma-separated values ranging from: −50 us to 593 µs and 9.91E+37 if no offsets
Query
are specified
Resolution: 1 ns
*RST Setting Time offsets 1 through 12 are on and set to these values:
time offset 1 = −28 µs
time offset 2 = −18 µs
time offset 3 = −10 µs
time offset 4 = 0 µs
time offset 5 = 321.2 µs
time offset 6 = 331.2 µs
time offset 7 = 339.2 µs
time offset 8 = 349.2 µs
time offset 9 = 542.8 µs
time offset 10 = 552.8 µs
time offset 11 = 560.8 µs
time offset 12 =570.8 µs
Programming Example
OUTPUT 714;"SETUP:PVTIME:TIME:OFFSET -28.0 US, -18.0 US, -10.0 US, 0"
!Configures the first four time offset points and turns the remaining eight off.
!Using the query form of this command would return four time offset values
OUTPUT 714;"SETUP:PVTIME:TIME:OFFSET -28.0 US" !Configures the first time offset
OUTPUT 714;"SETUP:PVTIME:TIME:OFFSET" !Turns all 12 offset points off. Using the
"Power versus Time Measurement Description" on page
!point and turns the remaining
!eleven off. Using the query form
!of this command would return one
!time offset value
!query form of this command would return
!9.91E+37 (NAN)
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_setup_pvtime.fm
SETup:PVTime
88.
429