Agilent Technologies 8960 10 Series Reference Manual page 356

INITiate
INITiate:<measurement mnemonic>[:ON]
Function Starts measurements with the test set.
The INITiate command is associated with the SETup command, and the FETCh? command, see
"SETup Subsystem" on page 379
One or more measurements may be initiated on the same program line. See
Measurements" on page
This command is also used to activate a measurement. See
(how INIT commands are used)" on page
Programming Example
OUTPUT 714;"INITIATE:TXPOWER:ON" !Initiates a TX Power measurement.
OUTPUT 714;"INITIATE:TXPOWER;PFERROR:ON" !Initiates TX Power and
!phase and frequency error measurements.
OUTPUT 714;"INITIATE:PVTIME;ORFSPECTRUM;FBERROR:ON" !Initiates power
!versus time output RF spectrum, and fast bit error rate measurements.
XXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
INITiate:<measurement mnemonic>:OFF
Function Deactivates the selected measurement. See
Only one measurement can be deactivated at a time, to stop one or more measurements and leave
them in the active state, see
Programming Example
OUTPUT 714;"INITIATE:TXPOWER:OFF" !Deactivates TX power measurement.
INITiate:COUNt?
Function Queries the number of measurements that have been initiated (that are activate). See
"Measurement States" on page
Query Range: 0 to 10
Resolution: 1
XXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
356
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_initiate.fm
and "FETCh? Subsystem" on page
122.
353.
"Measurement States" on page
"ABORt" on page 216.
150.
295.
"Concurrent
"INITiate Programming Examples
150.