Step2: Mark the installation position with the mounting plate 1. The distance between the two mounting
holes is 300mm.
Step3: Rotate the direction of mounting plate 1 and plate 2, install them again.
2.4 Install the inverter/charger
Risk of explosion! Never install the inverter/charger in a sealed enclose with flooded
batteries! Do not install the inverter/charger in a confined area where the battery gas
WARNING
can accumulate.
The inverter/charger can be fixed to the concrete and solid brick walls and cannot
be fixed to the hollow brick wall.
The inverter/charger requires at least 20cm of clearance right and left and 50cm of
CAUTION
clearance above and below.
14