Table of Contents
Advertisement
2-2 MEMORY INSTALLATION
WARNING!!!
• Make sure that you unplug your power supply when adding or remov-
ing memory modules or other system components. Failure to do so
may cause severe damage to both your mainboard and expansion
cards.
• Be careful when inserting or removing DIMM, forcing a DIMM in or out
of a socket can be damaged the memory module or the socket. Some of
DIMMs contain EDO or FTP DRAM. These DIMM types are incompliant
with the motherboard, the M/B only supports 3.3V true SDRAM DIMMs
Installing DIMM
• Make sure you have the correct memory module type for your
motherboard.
• Insert the module(s) as shown, DIMMs have 168-pins and two notches
that will match with the onboard DIMM socket, memory modules are
installed by inserting them straight into the slot until they "click" into
place. They only fit in one direction so do not force them into place.
168-Pin DIMM Notch Key Definitions(3.3V)
Removing DIMM
• Press the holding clips on both sides of socket out ward to release
the DIMM out of the socket.
DRAM Key Position
Voltage Key Position
Unbuffered
3.3V
75KAV/75KAV-X
15
Advertisement
Table of Contents
