Table of Contents
Advertisement
Installation
Connecting signal output cables
4. Install a second INET cable between the IN receptacle on the
For an INET system, communication among instruments on the loop
should be made only via installed INET cables. If you have capability of
installing a remote start/stop cable (see next section) between the
HP 5890 and the INET controller, this should not be done at the same
time INET cables are connected.
Remote start/HP 5890 ready cables
The REMOTE receptacle provides a function used primarily to start an
integrator or data system when an HP 5890 run begins, and also provides
ready information.
Pin No.
Color
1
Green
2
Brown
3
Blue
5
Gray
6
Violet
7
Orang
e
8
Black
9
Yel-
low
12
Red
Remote Start/HP 5890 Ready Cables
HP 5890, and the OUT receptacle on the previous device included in
the loop.
05890-6105
0
or
05890-6106
0
05890-61070
05890-61080
43
Advertisement
Table of Contents
