Installation
Connecting supply gases
7. Replace the carrier gas connector and turn on the gas to a pressure of
Gas supply tube connections
Assemble the fittings as shown. Push the tubing into the fitting as far as
it will go, then tighten the fitting by hand (no wrench). Use a wrench to
tighten further (3/4•turnfor 1/8•inchtubing, 1•1/4•turn for 1/4•inch
tubing).
28
50 to 60 psi. Leak test your work.
Flow restrictor
Carrier gas inlet fit-
ting
Plat
e
Scre
w