Table of Contents
Advertisement
Installation
Connecting signal output cables
Note that the general purpose and HP 3350Series LAS analog output
cable assemblies consist of two independent cables, terminating together
at a common, single, female plug at the HP 5890. One cable is labelled 1
mV, the other +1 V output. In general, the +1 V cable is connected to an
integrating device or A/D converter, and the 1 mV cable is connected to a
chart recording device.
Analog Signal Output Cables
Part No.
35900-60610
05890-60760
05890-60790
05890-60780
05890-60800
Note: Information above pertains to the +1 V cable. The 1 mV cable terminates
in spade lugs for cable Part No. 05890-60790 and -60800.
1. Insert the cable plug into the SIGNAL 1 or SIGNAL 2 male
Note: The SIGNAL 2 analog output receptacle does not function unless
the Option 550/Accessory 19242A (Communications Interface Board) or
Option 560/Accessory 19254A (RS•232•C Interface Board) is installed.
40
Typical Use
to HP 3394/96A
Integrator
to HP 3390/92/93A
Integrator
to HP 3350 Series
Lab Automation
Systems
to HP 3388A
Integrator
General Purpose
receptacle. The plug may be inserted in either of its two possible
orientations.
Length
Connector Type
2 m
Edge Connector:
HP 3394/96A Integrator,
1 V input
2 m
Edge Connector:
HP 3390/92A Integrator,
1 V input
2 m
Edge Connector:
HP 18652A A/D Converter,
1 V input
2 m
Push-On Terminals:
1 V A/D inputs
2 m
Spade Lugs
Advertisement
Table of Contents
