Internet Web Access:
Allow Access:
If enabled, allow user to access the device from the Internet via WEB.
►
IP Limit:
If enabled, allow only specific IP range to access the device from the Internet via
►
WEB.
IP Range:
If IP Limit enabled, specifies the IPv4 address range that is only allowed to access
►
to the device from the Internet via WEB.
IPv6 Range:
If IP Limit enabled, specifies the IPv6 address range that is only allowed to access to
►
the device from the Internet via WEB.
Intranet Web Access:
Allow Access:
If enabled, allow user to access the device from the Intranet via WEB.
►
IP Limit:
If enabled, allow only specific IP range to access the device from the Intranet via
►
WEB.
IP Range:
If IP Limit enabled, specifies the IPv4 address range that is only allowed to access
►
the device from the Intranet via WEB.
IPv6 Range:
If IP Limit enabled, specifies the IPv6 address range that is only allowed to access
►
the device from the Intranet via WEB.
3.4.4.4.2 TELNET
Choose the menu Data Service→Firewall Config→Netword Access-Ctrl→TELNET to load the
following page.
The following items are displayed on this screen:
Port:
Port when using telnet tools access device.
►
Internet Web Access:
Allow Access:
If enabled, allow access to the device from the Internet via telnet.
►
IP Limit:
If enabled, allow only specific IP range to access the device from the Internet via
►
telnet
IP Range:
If IP Limit enabled, specifies the IPv4 address range that only allow access to the
►
device from the Internet via telnet.
IPv6 Range:
If IP Limit enabled, specifies the IPv6 address range that only allow access to the
►
device from the Internet via telnet.
BG9008W User Manual
Figure 3-54 Configure Telnet Access-Ctrl
Page 40 of 133