Table of Contents
Advertisement
The following items are displayed on this screen:
Enable:
►
Type:
►
VLAN Enable:
►
VLAN ID:
►
Priority Level:
►
Primary DNS:
►
Secondary DNS:
►
Username:
►
Password:
►
Service Name /AC Name:
►
LCP Interval:
►
LCP Max Fails:
►
are send without receiving a valid LCP echo-reply.
Input "2" to configure VOICE parameter as below:
BG9008W User Manual
Figure 5-19 Configure DATA Interface Parameter
Enable this WAN interface (DATA can't be disabled).
Select PPPoE if your ISP provides xDSL Virtual Dial-up connection.
Optional. Enable VLAN to configure VLAN ID and VLAN Priority Level.
Optional. VLAN ID of this WAN interface.
Optional. VLAN Priority Level of this WAN interface.
Enter the IP address of your ISP's Primary DNS (Domain Name Server)
manually. If you are not clear, please consult your ISP. It's not allowed to
access the Internet via domain name if the Primary DNS field is blank.
Optional. If a Secondary DNS Server address is available, enter it.
Enter the Account Name provided by your ISP. If you are not clear, please
consult your ISP.
Enter the Password provided by your ISP.
Optional. The service name and AC (Access Concentrator) name, which
should not be configured unless you are sure it is necessary for your ISP. In
most cases, leaving these fields blank will work.
PPPoE will send an LCP echo-request frame to the peer every LCP interval
seconds.
PPPoE will presume the peer to be dead if LCP Max Fails LCP echo-requests
Page 142 of 133
Advertisement
Table of Contents
