Table of Contents
Advertisement
The following items are displayed on this screen:
►
SP Network:
Other or Swisscom. If it is not the target user, you need to select the other.
►
Connect Mode:
Manual or Auto. The default is Auto.
►
Online Mode:
always online and disconnect after idle interval. The default is "always online".
The default idle interval is 60 seconds.
If Other is selected, the following parameters appear:
►
Username:
3G network dial-up username.
►
Password:
3G network dial-up password.
►
Dial Number:
3G network dial numbers.
►
APN:
3G network access APN.
►
PIN:
3G networks need to use dial-up PIN code, if not, can be set to empty.
Advanced Parameters:
►
Authentication:
►
DNS:
►
TCP MSS:
►
MTU:
►
Data Link Backup:
►
Heartbeat Address:
The command "show 3gmodem-status" show the 3G modem status as below:
BG9008W User Manual
Figure 5-5
Configure 3G Modem Parameters
3G dial-up authentication, CHAP,PAP,Auto are provided. Default is Auto.
The default is obtained from the dial-up network devices automatically. You can
also configure DNS manually.
Configure TCP maximum segment, we recommend using the default value.
Configure 3G link MTU, the default value is recommended
When enabled, if WAN uplink port is disconnected, the routing switches to the 3G
link.
Set the heartbeat detecting address of the link, the default configuration is not
required.
Page 135 of 133
Advertisement
Table of Contents
