Gaoke BG9008W User Manual page 29

which can automatically adjust the channel width for your clients. If you choose to
11n or 11b/g/n Wireless mode, this configuration is required. Two values of width
are provided: 20MHz and 20/40MHz.
The Service Set Identifier (SSID) is used to identify an 802.11 (Wi-Fi) network and it's discovered by
network sniffing/scanning. BG9008W provides up to four SSID.
► Enable:
►SSID Name:
► Bind Interface:
► Enable Broadcast:
► Isolated:
► LAN Isolated:
► Max Client:
► SSID AP Isolated:
3.3.4.2 Security
Choose the menu Network→WLAN→Security to load the Security page. There are nine wireless
security modes supported by the device: Open WEP, Shared WEP, WEP Auto, WPA-PSK, WPA2-PSK,
WPAPSK/WPA2PSK, WPA, WPA2 and WPAWPA2.
If you do not want to use wireless security, select Disable, but it's strongly recommended to choose one
of the following modes to enable security.
1) WPA-PSK, WPA2-PSK, WPAPSK/WPA2PSK: It's the WPA/WPA2 authentication type based on
pre-shared passphrase. Choose one of these types, the following page is loaded.
The following items are displayed on this screen:
► SSID:
► Authentication:
► Algorithm:
BG9008W User Manual
Enable or disable this entry of SSID. SSID1 can't be disabled.
Enter the name of SSID. The name of SSID must be unique in all wireless
networks nearby.
Select a network interface to be bridged to the SSID.
When wireless clients survey the local area for wireless networks to associate
with, they will detect the SSID broadcast by the device. If you select the Enable
Broadcast checkbox, the device will broadcast its name (SSID) on the air.
Enable or disable isolate different clients from the same wireless station.
Enable or disable isolation between the LAN and SSID.
Enter the maximum number of clients allowed to connect to the SSID.
This function can isolate wireless stations on your network from each other.
Wireless devices will be able to communicate with the Router but not with each
other. To use this function, check this box. AP Isolation is disabled by default.
Figure 3-15 Configure WIFI PSK Security
The SSID enabled in WLAN→Basic Settings page.Read only
The authentication type selected: WPA-PSK, WPA2-PSK, WPAPSK/WPA2PSK.
When WPA2-PSK or WPAPSK/WPA2PSK is set as the Authentication Type,
you can select either TKIP, or AES or TKIP/AES as Encryption. When
WPA-PSK is set as the Authentication Type, you can select either TKIP or AES
as Encryption.
Page 18 of 133