Table of Contents
Advertisement
The following items are displayed on this part.
►
Interface Name:
►
IP Address:
►
Netmask:
►
NAT:
►
Assign NAT IP:
►
Enable DHCP Server:
►
Start IP:
►
End IP:
►
Netmask:
►
Gateway:
►
Primary DNS:
►
Secondary DNS:
►
Lease Time(Second):
Advanced Parameter
►
LAN Port:
►
WAN Subinterface:
2) Part 2: Configure LAN Route/Bridge mode
The following items are displayed on this part.
►
Port:
The physical LAN port name (LAN1~LAN4).
►
Route/Bridge:
Mode of this physical LAN port. The following four modes are provided:
Route: route to WAN
Transparent bridge: not modify the packets;
Tagged bridge: LAN untagged, WAN tagged; only 1 VID supported
Promisc Mode: Tagged packets in bridge mode, untagged packets in route mode;
most 5 VIDs supported (e.g. 8, 10, 13).
►
VLAN ID List:
If Tagged bridge/Promisc Mode is selected, configure the VID/VIDs.
3) Part 3: Configure IPTV
Choose the menu Network→LAN→Advanced Parameters to load this page.
BG9008W User Manual
Name of this LAN interface.
Enter the IP address for this LAN interface.
Enter the subnet mask for this LAN interface.
Optional Enable or disable NAT for this LAN interface
Optional If NAT is selected. NAT IP address can be assigned.
Enable or disable DHCP server on this LAN interface.
If Enable DHCP Server is selected, enter the Start IP address to define a
range for the DHCP server to assign dynamic IP addresses. This address
should be in the same IP address subnet with the IP address of this LAN
interface.
If Enable DHCP Server is selected, enter the End IP address to define a
range for the DHCP server to assign dynamic IP addresses. This address
should be in the same IP address subnet with the IP address of this LAN
interface.
If Enable DHCP Server is selected, enter the Netmask to define a range for
the DHCP server to assign dynamic IP addresses.
Optional .If Enable DHCP Server is selected, enter the Gateway address to
be assigned.
Optional. If Enable DHCP Server is selected, enter the Primary DNS server
address to be assigned.
Optional. If Enable DHCP Server is selected, enter the Secondary DNS
server address to be assigned.
If Enable DHCP Server is selected, specify the length of time the DHCP
server will reserve the IP address for each client. After the IP address
expired, the client will be automatically assigned a new one.
Select the physical LAN port to bind the IP address of this LAN interface.
Select the WAN subinterface which the packet from this LAN interface can
be sending to.
Page 16 of 133
Advertisement
Table of Contents
