SE LP10 Mortise Lock
4 Install Lock Body
A. First insert lock body wire harness into the mortised area and out of the inside cylinder hole (Fig. 4A).
B. Insert mortise lock body into mortise door preparation, continuing to feed wires from lock body through
the non-cylinder (inside) hole of the door preparation.
C. Hold lock body loosely in place with (2) lock body screws (wood or metal depending on type of door).
NOTE: Do not completely tighten screws at this time.
A8113H • 800-810-WIRE (9473) • www.sargentlock.com
Inside of Door
(2) #12-24 x 1/2"
Flat Head Philips
Screws (Metal Doors)
Fig. 4A
(2)#12 x 1-1/4" Flat
Head Wood Screws
(Wood Doors)
Fig. 4B
13