Summary of Contents for Assa Abloy SARGENT DL Series
Page 1
Installation Instructions Installation Instructions DL Series Tubular Lock Tools Required • #2 Phillips screwdriver • 1/8" drill bit • 1" drill bit • T20 sized security bit • 2-1/8" drill bit • Right angle square (square roses) Product Components Item Description Lever Set Screw...
Page 2
DL Series Tubular Lock Installation Instructions Installation Passage (DLU15) and Privacy (DLU65) Functions IMPORTANT For proper installation, the spring housing assembly with sticker should have arrow pointing towards latchbolt and be legible during installation. See Figure 1. 1. Install latch using (2) #8-32 x 3/4" screws. Install loosely; tighten Figure 1 after step #5.
Page 3
DL Series Tubular Lock Installation Instructions Installation, Continued. Single Lever Pull (DLU93) Function Figure 7 1. Install inside mounting plate assembly using (2) #8-32 x 3/4" screws. Note location for set screw. 2. Install rose onto spring housing assembly. See page 4 if Square Roses.
Page 4
Square Rose Installation (Figure 9) 1. Install latch, outside assembly and inside spring Figure 9 housing assembly per function. 2. Position square mounting plate over spring housing, See Figure 10. 3. Drill two centered pilot holes for the #6-32 mounting screws in the upper right and lower left portions of the square mounting plate.