Connecting Gigabit Ethernet Sfp Ports; Connecting 1000M Ethernet Tx Ports - Bdcom S2528PB Hardware Installation Manual

3.3.2 Connecting Gigabit Ethernet SFP Ports

The S2528PB switch has 4 gigabit SFP ports. Each port has a corresponding
indicator for showing their LINK/ACT state. If the indicator is always on, the port is
normally linked; if the indicator flickers, the data is forwarded through the port. In
use the SFP optical module can be connected to the SFP optical module and
connected to other Ethernet terminal devices through the optical cable.
Figure 3-6 Gigabit SFP ports connect to other Ethernet terminal devices

3.3.3 Connecting 1000M Ethernet TX Ports

S2528PB provides 24 10/100/1000Base-T ports. Each port corresponds to one
LINK/ACT indicator and POE indicator. In use, the ports can connect other Ethernet
terminal devices through the UTP port and the direct-through or cross network
cable. The numbering order of the pins in the UTP port is the same as the console
port. See the following figure:
Figure 3- 5 Cable connection at the console port
S2528PB Hardware Installation Manual
- 12 -