Bdcom S2528PB Hardware Installation Manual page 14

Figure 3-4: Connecting the console port of S2528PB with the computer
No. Name
1 CD
2 RXD
3 DSR
4 TXD
5 RTS
6 CTS
7 DTR
8 SG
Note: The console port of the S2528PB switch does not support traffic control. Therefore, you
must set the option data traffic control to none when you configure the switch with the super
terminal. Otherwise, the single-pass problem will arise on the super terminal. The cable is used
to connect the console port of the S2528PB switch and the outside console terminal device.
One end of the console port is RJ45 8-core plug and the other end of the console port is a
25-hole plug and a 9-hole plug. The RJ45 plug is put into the socket of the console port on the
S2528PB switch. DB25 and DB9 is alternative. RJ45 connects to DB9 in the console port
shown as below.
Figure 3- 3 RJ-45 connector of the console port
Table 3-1 Definition of the pins of the Console port
S2528PB Hardware Installation Manual
Remarks
No connect
Input
No connect
Output
No connect
No connect
No connect
GND
- 11 -