Function At The Operator Level; Actual Value To Reference; Direct Entry To Value To Reference; Switching Incremental Or Absolute - ELGO Electronic IZ16E-000 Series Operation Manual

10.5 Function at the Operator Level

 Working with the device

10.5.1 Actual Value to Reference

With this shortcut, the actual value (display value) on the adjustable reference value is set (in absolute mode only
possible when the offset is not enabled).
The reference value can be entered with the parameter P09.

10.5.2 Direct entry to value to reference

(Function is possible at firmware 1.30)
With this key combination, the value to reference P09 can be entered without switching into the parameter level.
(see on chapter 10.3)
After pressing the keys for approximately 3 seconds, the display shows the text ''P09''.
If the keys are released the value to reference P09 appears, and this value can also be changed in the
parameter level.

10.5.3 Switching incremental or absolute

With this key the indicator is switched from absolute mode to incremental mode:
 The display value is temporarily set to ZERO, the symbol „INC" appears in the display.
Actuating the key again the absolute is activated and the symbol "ABS" is displayed.

10.5.4 Activation Offset Measurements

This key enables/disables each of the three adjustable offset dimensions (only possible in the absolute mode). In
each case an offset is added to the display value.
The activation of an offset level is indicated by the symbols
The offset measurements can be entered in the parameter P10, P11 and P12.
Additionally, parameters can be determined with P13, whether and how many offset measurements can be
selected.
Keys 1x press at the same time
Keys 1x press at the same time
Key 1x press to safe the value to reference
1x pressed
1x pressed
1 2 3
, or .
38
Structure and Function